How to extend the using service of stainless steel sintered filter element?

Maybe you are confused about the short using time of stainless steel filter element.

How to Extend the Lifespan of Stainless Steel Sintered Filter Element ?

As We Know Till Now, Stainless steel sintered filter elements are commonly used in various industries such as oil and gas, chemical, and food processing because of their durability and resistance to corrosion. To extend the lifespan of your stainless steel sintered filter element, here are some tips we advice, please check it :

1. Proper Installation:
It's important to install the filter element correctly and according to the manufacturer's instructions. This will ensure that it's functioning optimally and reduce the risk of damage during installation.

2. Regular Cleaning:
The filter element should be cleaned regularly to prevent clogging and to maintain its effectiveness. A good cleaning schedule is every 3 to 6 months, depending on the amount of use and the type of material being filtered.

3. Use Compatible Fluids:
It's better to sure that the fluid being filtered is compatible with the filter element's material. This will prevent any chemical reactions that could damage the sintered filter element body.

4. Replace O-Rings:
Also the O-Ring also be important, The O-rings in the filter housing should be replaced regularly to prevent leakage, which could cause damage to the filter element.

5. Don't Overload:
Also Appropriate amount of filtration is very important, Don't overload the filter element beyond its recommended capacity. This could cause damage to the filter element and decrease its effectiveness.

6. Keep it Dry:
After cleaning or use, You Need to make sure to dry the filter element thoroughly before reassembling it. Because Any Moisture may cause corrosion and shorten the lifespan of the filter element.

7. Store Properly:
If you need to store the filter element, please make sure to store it in a clean and dry area. Also it's better to Avoid storing it near chemicals or in areas with high humidity.

By following these tips, you can extend the lifespan of your stainless steel sintered filter element, which will save you money in the long run and prevent any production interruptions.

Also we need to reply the new sintered filter after using about 2-3 monthes.

Why we need to replace filter element frequently?

1.Filtering the raw water.

There are lots of impurity such as sediment particles and dust in raw water that cause to much too granular material into the filter element and blocking the pores of the filter element, resulting in shortened service life. Clean regularly is vital to avoid the pollutants blocking the pores of sintered filter core affecting filtration efficiency.

2.False methods in the pretreatment process

Some industries will add flocculants and anticrustator in raw water. It will cause the effective filter area of the filter element is reduced, and the filter effect is poor, resulting in frequent replacement of the filter element.

3.Maintenance and cleaning have been ignored.

If the surface of the filter element is adhered to by strong acid and alkaline substances, it should be washed with water immediately, and then bathed with neutral carbonated soda solution. Hydrochloric acid will destroy the passivation layer on the surface of stainless steel, and eventually cause the rust of the filter element to be replaced. Therefore, maintenance and cleaning is important for the stainless steel filter element.